Operation process of 200L fully automatic single head filling machine

The 200L fully automatic single head filling machine is an efficient and precise liquid filling equipment, suitable for filling various liquid products into standard barrels of 200 liters. The following is a general operating procedure, and the specific steps may vary depending on the equipment design and configuration of different manufacturers:

Power on preparation:

Check the working environment around the filling machine to ensure there are no obstacles or hazardous factors.

Confirm that all safety devices are in place and functioning properly.

Check the main components of the filling machine, such as pumps, pipelines, valves, weighing systems, etc., to ensure they are clean and undamaged.

Prepare the liquid products to be filled and empty barrels.

Startup:

Turn on the main power switch and start the control system of the filling machine.

Perform system self-test according to the instructions on the control panel to ensure that all parameter settings are correct.

Parameter settings:

Set parameters such as filling volume and filling speed based on the characteristics of the product to be filled.

If necessary, adjust the position and height of the filling head to accommodate barrels of different sizes.

Positioning of the bucket:

Place the empty bucket in the filling position, usually on a weighing platform.

Ensure that the opening of the bucket is aligned with the filling head and the bucket is stable and not moving.

Start filling:

Select "Start Filling" or similar command on the operation panel.

The filling machine will automatically start and begin filling liquid into the barrel.

The weighing system will monitor the filling weight in real-time, and once it reaches the preset value, the filling machine will automatically stop.

Filling completed:

After filling is completed, the filling head will automatically lift away from the barrel mouth to prevent dripping.

If necessary, perform sealing or capping operations.

Remove bucket:

Remove the filled barrels from the weighing platform and place them in the designated location or on the conveyor belt.

Cleaning and maintenance:

After each filling, the filling head and related components should be cleaned to prevent contamination or blockage caused by residues.

Regularly maintain and upkeep the filling machine to ensure its long-term stable operation.

Shutdown:

After completing all filling tasks, turn off the control system and then turn off the main power switch.

Clean up the work area to ensure safety and cleanliness.

Throughout the entire operation process, the operator should closely monitor the operational status of the equipment to ensure everything is functioning properly. If any abnormal situation is encountered, the operation should be stopped immediately and technical personnel should be notified for inspection and repair. In addition, operators should receive appropriate training and be familiar with the operating procedures and safety precautions of the equipment.